What is actually measuring the weather here, how the numbers get from the instruments to the page, and what you can do with them. This is the least glamorous corner of the site and, for anyone who wants to run their own station or reuse the data, the most useful.

The hardware

The station is an Ecowitt installation at Marybank, on the western edge of Stornoway, at about 50 metres above sea level:

  • Ecowitt GW-1100 — 7-in-1 outdoor sensor array: temperature, humidity, pressure, wind speed and direction, UV, light and rainfall.
  • GW3000 and GW1101 gateways — the Wi-Fi bridges that get the data off the array and onto the network.
  • WH57 — lightning detector, listening across roughly a 40 km radius.
  • WH51 — soil moisture probe.
  • HP10 — the timelapse camera behind the timelapse videos.
  • Tuya and Metriful MS430 — indoor air quality and environment sensing.

The weather station components page goes through each item and what it contributes; local weather in Marybank covers the siting and the reasoning behind where things were put.

How the data moves

Two independent paths bring the observations in, which is deliberate — if one fails the dashboard keeps going:

  • clientraw — the Weather Display format, written every 12 seconds. This is the fastest and most granular source, and it is what drives the “live” feel of the readings.
  • Ecowitt Cloud API — the manufacturer’s cloud feed, updated on a slower cadence. It acts as the cross-check and the fallback.

Everything else is fetched rather than measured, and each source is credited on the dashboard:

  • Forecast — Open-Meteo, 2 km model, run at the station’s coordinates.
  • Space weather — NOAA SWPC for Kp, solar wind and Bz.
  • Tides — Stormglass, for Stornoway, relative to mean sea level.
  • Warnings and marine — the Met Office, for Highlands & Eilean Siar and the Hebrides inshore waters.

On the site the sources are listed with a health status, so you can see at a glance whether a stale number is a sensor problem or a fetch problem. That was worth building: when the pressure reading looks wrong, the first question is always whether it is the instrument or the internet.

Software at the station end

The desktop and server side is mostly Weather Display, which writes the clientraw feed and has been quietly reliable for years. Around it:

Hardware I have actually used

Siting: why your numbers will differ from mine

A weather station measures its own surroundings as much as the weather. Mine sits on the western edge of Stornoway, slightly inland and away from the harbour, which means:

  • Wind speed reads lower than the seafront and lower than Stornoway Airport a few miles east.
  • Overnight minima run slightly cooler than the town centre, as you would expect from a site with more exposure.
  • Rainfall is a point measurement. A shower that misses the gauge by 500 metres still counts as a dry day in the record.

None of that is a defect — it is what a station is. The weather glossary covers the instrument-level terms if any of the readings on the dashboard are unfamiliar.

Reusing the data

The dashboard is not the only way out. There are JSON endpoints behind it, including the live station payload and the ferry status feed, and they are the same data the dashboard uses:

  • /wp-json/mm0zif-station/v1/current — current conditions, seven-day forecast, outlook, almanac, space weather, tides, marine and warnings in one response.
  • /wp-json/mm0zif/v1/ferry — Ullapool–Stornoway status, combined with wind at both ends of the route.

The live readings are published for personal and educational use. For commercial use, a data feed or attribution questions, email marcus@mm0zif.radio. The weather data is observational, not an official forecast — for anything safety-critical, use the Met Office.

Start at the live dashboard if you just want the weather, or the Isle of Lewis weather hub if you want the wider picture.